Been laying out the wiring harness through the centre console and looking to see how all the required lines will go. Especially how all the lines will go and not clash. Getting past the elevator torque tube. It’s very busy. In the centre console are: Rudder cables x2 Antenna coax x 4 placed in grey plastic flame retardant conduit Fuel lines x 4 used a 3D printed spacer for rudder cables Rudder cable x2 Wiring harness Pitot and AOA pipes Throttle cable Brake fluid header pipe Rear connections The magnetometer has to be fitted in the rear fuselage through an inspection hatch. Quite a fiddly job to do. Brass screws with locktite without dropping a screw that will rattle forever. Then fit a zip tie on the pr existing clamp provided by the factory, so that the magnetometer cable doesn’t go near the rudder cable. 28/2/2022 Tidied up the centre console wiring and added the pitot and angle of attack lines.
More